Why Do Wireless Modules Suffer Communication Latency? Common Causes and Optimization Strategies
The answer: In industrial automation, security alarm and remote telemetry projects, many engineers face delayed data transmission — after the system sends a control command, the receiver may take hundreds of milliseconds or even seconds to respond. Wireless transparent-transmission modules (such as EBYTE's E22 series based on the Semtech SX1262/SX1268 architecture, FSK/GFSK modules, etc.) contain multiple buffering stages, over-the-air modulation and protocol verification in the transmission link. Communication latency is not caused by a single hardware fault but by the accumulated time overhead of the entire chain. This article provides an in-depth analysis from three dimensions: latency composition, key contributing factors, and engineering optimization.
1. Breaking Down the Time Composition of Wireless Transmission Latency
The total latency T_total of a complete packet — from transmission by the TX-side MCU to completion of processing at the RX-side MCU — is the sum of four core time segments:
Following the link order, the four components are:
- UART transmission time (T_uart_tx / T_uart_rx): the time to move data between the MCU and the module's UART pins at the configured baud rate.
- Packet-assembly delay (T_pack): when receiving the UART byte stream, the module firmware typically relies on a byte timeout to judge the end of a packet (e.g., no new input for 2–4 byte times is treated as packet completion).
- Time on Air (T_air): the over-the-air RF modulation duration required for the RF chip to transmit the preamble, physical header, data payload and CRC.
2. Core Causes of High Communication Latency
Based on the link composition and field practice, the core causes of high latency concentrate in the following four areas.
2.1 Improper UART Baud Rate and Packing Timeout Settings
Many developers habitually keep a low 9600 bps UART baud rate. Taking a 100-byte transmission as an example:
- At 9600 bps, one-way UART transfer alone takes 100 × 10 / 9600 ≈ 104 ms;
- Accumulated on both TX and RX sides, pure UART time already exceeds 200 ms.
In addition, some modules retain a long (e.g., tens of milliseconds) UART idle timeout by default for variable-length data compatibility, directly delaying the trigger point at which data is sent.
2.2 Air Data Rate Configured Too Low
In LoRa modulation, a high spreading factor (e.g., SF12) brings excellent sensitivity, but the spreading ratio greatly increases the per-symbol duration. Taking a single 64-byte packet as an example:
- At a 2.4 kbps air rate, the time on air (T_air) including preamble is typically 250–350 ms;
- Switching to a 62.5 kbps air rate, T_air needs only 10–20 ms.
An overly conservative air-rate choice is the single largest physical factor causing long delays.
2.3 Channel Conflicts and Blind Retransmission
In point-to-multipoint or multi-master/multi-slave network topologies, if multiple nodes transmit on the same frequency without carrier sensing (LBT/CAD), radio collisions occur in the air, causing the receiver to drop packets directly on CRC errors. When the application layer times out waiting for an ACK, retransmission is triggered; retransmission waiting and backoff mechanisms degrade end-to-end latency by multiples.
|
Tell us what you need. We'll send you the best deal Shipping notice: For door-to-door / DDP service to the US, Canada, and Europe Shop on RobotShop How to Order: Submit Your Request Free Samples for University Students— University-Sponsorship Applications |